|
|
 |
|
|||||||||||
 |
||||||||||||
 |
||||||||||||
|
__________ Cisco MultilinkPPP (MLPPP) configuration. __________ Cisco Serial Back-to-Back Connectivity. __________ __________ __________ Cisco and Juniper E1 cross cable connectivity. __________ Cisco Serial Bundling configuration. __________ Cisco and Juniper Serial Back 2 Back Connectivity. __________
|
Cisco
1760 and Juniper J4300
Two E1 Cross cable Configuration
Hardware Details: » Cisco Router 1760 » E1 card (VWIC 1MFT-G703) » J4300 (Juniper Router) » E1 Module » E1 Cross cable.
(E1 cross cable configuration is)
Router
1760 E1 configuration Command
line configuration. Router# config terminal Router(config)# hostname RouterB E1
Controller configuration RouterB(config)# controller e1 1/0 RouterB(config-controller)# framing no-crc4 RouterB(config-controller)# clock source internal RouterB(config-controller)# channel-group 0 timeslot 1-31 RouterB(config-controller)# exit Serial
interface configuration. RouterB(config)# interface serial 1/0:0 RouterB(config-if)# encapsulation ppp RouterB(config-if)# ip address 172.10.10.2 255.255.255.0 RouterB(config-if)# exit
Reslts Router#show controllers e1 E1 1/0 is up. Applique type is Channelized E1 - balanced No alarms detected. alarm-trigger is not set Version info Firmware: 20030902, FPGA: 11 Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal. Data in current interval (546 seconds elapsed): 2189 Line Code Violations, 7972 Path Code Violations 10 Slip Secs, 2 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 10 Errored Secs, 0 Bursty Err Secs, 2 Severely Err Secs, 152 Unavail Secs Total Data (last 1 15 minute intervals): 0 Line Code Violations, 0 Path Code Violations, 0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins, 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 900 Unavail Secs Router# Router#show controllers e1 1/0 E1 1/0 is up. Applique type is Channelized E1 - balanced No alarms detected. alarm-trigger is not set Version info Firmware: 20030902, FPGA: 11 Framing is NO-CRC4, Line Code is HDB3, Clock Source is Internal. Data in current interval (605 seconds elapsed): 2189 Line Code Violations, 7972 Path Code Violations 21 Slip Secs, 2 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 21 Errored Secs, 0 Bursty Err Secs, 2 Severely Err Secs, 152 Unavail Secs Data in Interval 1: 0 Line Code Violations, 0 Path Code Violations 0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 900 Unavail Secs Total Data (last 1 15 minute intervals): 0 Line Code Violations, 0 Path Code Violations, 0 Slip Secs, 0 Fr Loss Secs, 0 Line Err Secs, 0 Degraded Mins, 0 Errored Secs, 0 Bursty Err Secs, 0 Severely Err Secs, 900 Unavail Secs Router# Router# show interface serial 1/0:0 Serial1/0:0 is up, line protocol is up Hardware is DSX1 Internet address is 172.10.10.2/24 MTU 1500 bytes, BW 1984 Kbit, DLY 20000 usec, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation HDLC, loopback not set Keepalive set (10 sec) Last input 00:00:00, output 00:00:00, output hang never Last clearing of "show interface" counters never Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 4 Queueing strategy: weighted fair Output queue: 0/1000/64/0 (size/max total/threshold/drops) Conversations 0/1/256 (active/max active/max total) Reserved Conversations 0/0 (allocated/max allocated) Available Bandwidth 1488 kilobits/sec 5 minute input rate 5000 bits/sec, 8 packets/sec 5 minute output rate 4000 bits/sec, 8 packets/sec 3051 packets input, 242978 bytes, 0 no buffer Received 48 broadcasts, 0 runts, 1 giants, 0 throttles 2 input errors, 0 CRC, 1 frame, 0 overrun, 0 ignored, 1 abort 3029 packets output, 243622 bytes, 0 underruns 0 output errors, 0 collisions, 3 interface resets 0 output buffer failures, 0 output buffers swapped out 3 carrier transitions Timeslot(s) Used:1-31, SCC: 1, Transmitter delay is 0 flags Router#
Continue to next page .............
|
|
||||||||||
|
|
||||||||||||
